Creatinine clearance > Protocol Section
Creatinine clearance protocol (16)
Collection of timed mouse urines
General procedure using the Nalgene Diuresis Cage (650-0322): a clean cage is prepared for use by lightly spraying the (1) metal mouse screen, (2) the mesh support grid and (3) the conical mouse funnel with silicone spray. Wipe off any excessive silicone and allow it to sit on bench to vent any fumes before assembling. This should be done periodically, but may last for months.
- Assemble cage as described by instructions. Attach either the 15 ml fluid collector or 30 ml collector based on your experience with the specific strain, size and number of mice you will place in cage.
- Place food in feeder and attach. Mice must have food overnight especially diabetic mice. Place autoclaved tap water (distilled water is also OK but deionized water should not be used) in water bottle and attach. In non-diabetic mice, sugar water (3-5% glucose or sucrose water can be used to insure complete collection (i.e. enough volume). For diabetic mice, they usually make enough urine without the need for sugar water. Check to make sure all connections are secure.
- Place mice in cage, and secure top on cage. Make sure to label cage with mouse ID number.
- Place 1.0 ml of water in the collection fluid collector (this provides some humidity in the cage).
- Label a 15 ml plastic centrifuge tube and use this to cover the vent hole in the top of cage.
- Collect over 24 hours (or any other known time interval).
- After allotted time period, remove mice and record time.
- Examine the inside bottom of cage to see if spots of dried urine are present. They will be easily apparent if present. Some mice, especially db/db and some stz induced diabetic mice have glucosuria, and spots of sticky urine do not flow down the conical. In this case, the collection tube is removed, and the bottom conical is removed and rinsed with a small volume of deionized or distilled water or urine from the collection tube. These rinses are combined with the urine in the collection tube. The volume is measured or weighed into a clean tared vessel. The volume is recorded to 3 significant figures.
- Urine should be separated from any feces by centrifugation and aliquoted if necessary into labeled tubes then frozen.
- Cages are cleaned with mild soap and water then rinsed thoroughly and dried before next use. If cages do not leave barrier room, we do not find it necessary to autoclave them between collections. Autoclaving gradually deteriorates the plastic.
Preparation of plasma, serum and urine for creatinine measurement by HPLC
For plasma and serum: Mix, and if necessary, squeeze any clot using wooden applicator stick, then centrifuge (minimum 3,000 rpm for 10 minutes). Label enough tubes for protein precipitation. Prepare acidified acetonitrile (ACN) by adding 50 μl of HPLC grade glacial acetic acid to 10 ml of HPLC grade ACN.
For a 25 μl plasma/serum: Use this ratio of 4:1 (ACN to specimen – 100 μl ACN to 25 μl plasma) if less or more specimen is used keep the 4:1 ratio. (3:1 or 5:1 is also OK)
For urine, mix and centrifuge then just use 5μl. This may be adjusted upwards if very dilute urine is used. The ACN of 100 μl is also used. In reporting of final concentration the value is multiplied by 5. (i.e. 5μl of original urine taken up in 25 μl of mobile phase).
- Transfer 25.0 μl of plasma (or 5 μl of urine) to each tube containing 100 μl of ACN; vortex about 15 seconds to mix, extracting the creatinine into the ACN. Let sit for about 15 minutes in the minus 20 freezer. This aids in precipitation and freezes the aqueous ppt. avoiding carryover and undissolved particles.
- Centrifuge (minimum 10,000 rpm @ 6º for 10 minutes) at 4 degrees.
- Transfer the supernatant to new clean labeled tube (1.5 or 0.5 ml Starstadt tubes work well).
- The volume should be very close to 125 μl. Careful not to transfer any of the ppt. (button) which should be on the wall or bottom of the tube.
- Evaporate the ACN to dryness using the Speed Vac, Centrivap or stream of dry nitrogen. Mild heat may be used if necessary in Speed Vac. This should take about 30 minutes.
- Remove the tubes and reconstitute to 25.0 μl with filtered Mobile Phase (Solvent A). Mix to dissolve the residue containing creatinine using the pipettor.
- Transfer the liquid containing the creatinine to the special Perkin Elmer tubes for autosampler. Cap with special slit caps and centrifuge (@2,000-3,000 rpm for 10 minutes). Use swinging bucket rotor to get any debris to go to the bottom. Carefully remove autosampler vials from centrifuge and transfer to the Peltier tray. Examine each tube to insure that the liquid is touching the bottom (the V) of the tube.
- Program the autosampler making sure the vials correspond to the numbers and the ID of the specimens. Check twice; they sometimes change.
- With each run, a banked quality control (QC) sample must be run. The QC is a previously assayed pooled mouse plasma that has been aliquoted and stored in a minus 20 freezer.
Assay for creatinine by High Performance Liquid Chromatography (HPLC)
All reagents are HPLC grade. All aqueous buffers are filtered through 0.22 micron filter. Tubing is PEEK 0.005 mm tubing with hand-tight connectors.
- Mobile phase: 5mM sodium acetate adjusted to pH 4.1 ± 0.1 with glacial acetic acid (final solvent strength is about 15 mM after acetic acid is added. Mobile phase was degassed.
- Column: Zorbax SCX, -- strong cation exchange, (Aglient, Wilmington, DE), 50 mm x 2.1 mm, 5μ particle size). Five micron in-line filter and SCX guard column placed in front of analytical column.
- Temperature and flow rate: Column run at 45 ± 0.5¼ C. at a flow of 0.30 ± 0.02 ml/min. Backpressure was around 900 psi. Runtime was 10 minutes.
- Detection: UV (deuterium source) at 225nm (flow cell volume is 12 μl).
- Injection volume: three microliters (3 μl) from auto sampler. Temperature of autosampler tray was 18 ± 0.5¼ C.
- Identification and quantitation: Identification by comparison of retention time to pure standard of creatinine. Average retention time was 3.654 ± 0.022 minutes. Quantitation was achieved by external standard ranging from 0.003 to 1.000 mg/dl by serial dilutions using a weighted 1/χ2 regression line (8-10 points). May also use Excel, Prism or any other software to calculate a regression line and compute the unknowns.
Calculation of creatinine clearance:
Publications for Creatinine clearance (1)
BACKGROUND: The use of endogenous plasma creatinine levels and creatinine clearance as a tool to evaluate renal function in mice has come under scrutiny as prior studies have reported that the Jaffe alkaline picrate method grossly overestimates true plasma creatinine in mice. As members of the NIDDK Animal Models of Diabetic Complications Consortium (AMDCC), we evaluated the performance and feasibility of an alternative high-performance liquid chromatography (HPLC)-based method for standard determination of plasma creatinine and creatinine clearance in mice. Our purpose was to develop a simple method that provides a reliable, reproducible, and sensitive assay for small volumes (<25 microL) of mouse plasma and sera. METHODS: We compared creatinine clearance measured by HPLC with the Jaffe method and HPLC creatinine clearance with inulin clearance [fluoroscein isothiocyanate (FITC) inulin in an osmotic pump implanted in mouse] in C57BL/6J mice. Different groups of mice underwent either one of two protocols. Protocol A included dietary intervention with normal, low salt plus enalapril, or high salt. Protocol B induced diabetes using streptozotocin. RESULTS: First, mean plasma creatinine levels were significantly lower (P < 0.0001) by HPLC (0.128 +/0.026 mg/dL) vs. Jaffe (0.4 +/0.12 mg/dL) for mice on a normal diet. Urine creatinine concentrations measured by HPLC were 10% lower than by Jaffe (P < 0.01). Second, mean creatinine clearance by HPLC for mice on a normal diet was 255 +/68 microL/min. Mice on low salt diet plus enalapril had reduced creatinine clearance (72.8 +/24.2 microL/min) while mice on high salt diet had an elevated creatinine clearance (355 +/105 microL/min). Third, diabetic mice (19 to 24 weeks of diabetes) exhibited hyperfiltration as creatinine clearance was 524 +/214 microL/min whereas nondiabetic age/gender-matched mice showed a mean creatinine clearance of 206 +/41 microL/min. Finally, significant correlation was demonstrated for creatinine clearance by HPLC vs. inulin clearance (R= 0.643; P < 0.001). CONCLUSION: HPLC is highly accurate, much more sensitive and specific than the Jaffe method for plasma creatinine measurements in mice. Creatinine clearance in mice measured by HPLC reflects changes in renal function induced by diet and diabetes.
|Service||Cost (Vanderbilt)||Cost (non-Vanderbilt)|
Click on the service name to request the service.
Additional content related to Creatinine clearance
Last updated on 2013-11-06 Moderated by Jimmy Hao